BBK Performance 79-93 Ford Mustang 5.0 High Flow Catted X-Pipe Auto

• Increases Horsepower and Adds an Aggressive Exhaust Note
• 2.5" Mandrel Bent Aluminized Steel Tubing
• High Flow Catalytic Converters for Maximum Flow
• For Use With BBK Long Tube Headers Part #1531 or Part #15310
• Cannot Be Sold or Shipped To California Residents
• Fits 79-93 Cars with AOD/E Automatic Transmission
• See Additional Vehicle Fitment Below

• 1979-1993 Ford Mustang 5.0L with BBK Part #1531 or Part #15310
• Also Fits* 1999-2004 Ford Mustang V6 BBK Long Tubes 1639 and 16390 

Complete Your Long Tube Header Install
Crank up the power potential of your 1979-1993 Mustang 5.0 with this BBK catted short X-pipe for use with automatic transmission. This BBK x-pipe will dramatically increase the sound of your Mustang to a roar that will be sure to turn heads. Not only is this catted X-pipe required to finish your long tube header install, it further improves exhaust flow, increasing horsepower, torque and throttle response.

High Quality
BBK Performance short x-pipes are designed from 2.5" mandrel bent steel tubing with high flow catalytic converters for maximum exhaust flow. The X-pipe features rear oxygen sensor bungs in the factory location making installation a breeze.

Installation
The X-pipe is intended for use with BBK long tube headers 1531, 15310, 1639 and 16390 which are designed specifically to clear the factory transmission.

Emissions
Please Note: The new catalytic converters used in the manufacture and production of ALL BBK Performance high flow H and X exhaust pipes meet Federal EPA requirements. (N/CE - New aftermarket Converter) Federal Catalytic Converters are not legal for sale, installation or use on ANY licensed vehicle in the State of California. These converters do NOT carry an Executive Order number (EO number) and are NOT California CARB approved. Please check your state and local emissions laws to ensure compliance.

*Fitment. Please Note on 1999-2004 Ford Mustang V6 (manual trans) BBK Long Tubes 1639 and 16390 - Exhaust Hangers must be cut off and air tube removed and blocked

Additional Emissions Information
This part is NOT C.A.R.B Approved and cannot be installed for use on any emission controlled vehicle in California.
It cannot be sold or shipped to any California resident or addressee.